#!/bin/ksh
SECS=300 # Defines the number of seconds for each sample
INTERVAL=2 # Defines the total number of sampling intervals
STATCOUNT=0 # Initialize a loop counter to 0, zero
OS=$(uname) # Defines the UNIX flavor
###################################################
##### SETUP THE ENVIRONMENT FOR EACH OS HERE ######
###################################################
# These "F-numbers" point to the correct field in the
# command output for each UNIX flavor.
case $OS in
AIX|HP-UX) SWITCH='-t'
F1=3
F2=4
F3=5
F4=6
echo "/nThe Operating System is $OS/n"
;;
Linux|SunOS) SWITCH='-c'
F1=1
F2=2
F3=3
F4=4
echo "/nThe Operating System is $OS/n"
;;
*) echo "/nERROR: $OS is not a supported operating system/n"
echo "/n/t…EXITING…/n"
exit 1
;;
esac
###################################################
######## BEGIN GATHERING STATISTICS HERE ##########
###################################################
echo "Gathering CPU Statistics using vmstat…/n"
echo "There are $INTERVAL sampling periods with"
echo "each interval lasting $SECS seconds"
echo "/n…Please wait while gathering statistics…/n"
# Use "iostat" to monitor the CPU utilization and
# remove all lines that contain alphabetic characters
# and blank spaces. Then use the previously defined
# field numbers, for example F1=4,to point directly
# to the 4th position, for this example. The syntax
# for this techniques is ==> $'$F1'.
iostat $SWITCH $SECS $INTERVAL | egrep -v '[a-zA-Z]|^$' /
| awk '{print $'$F1', $'$F2', $'$F3', $'$F4'}' /
| while read FIRST SECOND THIRD FOURTH
do
if ((STATCOUNT == 1)) # Loop counter to get the second set
then # of data produces by "iostat"
case $OS in # Show the results based on the UNIX flavor
AIX)
echo "/nUser part is ${FIRST}%"
echo "System part is ${SECOND}%"
echo "Idle part is ${THIRD}%"
echo "I/O wait state is ${FOURTH}%/n"
;;
HP-UX|Linux)
echo "/nUser part is ${FIRST}%"
echo "Nice part is ${SECOND}%"
echo "System part is ${THIRD}%"
echo "Idle time is ${FOURTH}%/n"
;;
SunOS)
echo "/nUser part is ${FIRST}%"
echo "System part is ${SECOND}%"
echo "I/O Wait is ${THIRD}%"
echo "Idle time is ${FOURTH}%/n"
;;
esac
fi
((STATCOUNT = STATCOUNT + 1)) # Increment the loop counter
done
